![]() ![]() ![]() I have noted many people making note online that their audio interfaces quit working when they updated to Mavericks. HELP!! This is obiously a patch or update that has to be addressed by either apple or Avid. I know there is a signal going through the Mbox2 because it does play back the quicktime videos and I can play my guitar through the interface and even get sound from the external speakers, so all hard connections are in place. One important thing to note is the my coreaudio driver no longer. I am using Digidesign firmware v1.38 and have downloadedhttp:/mbox2firmwareintel_28750-2,Mbox_2_Driver_v90_69594-2,Mbox_1_2_0_Drivers_80535all to no avail. THE AVID DIGIDESIGN SITE is recommending not to upgrade to Mavericks, would have been nice to know this before I rendered my very much needed audio interface unusable. The funny thing is I can play a video using quicktime and the interface works fine. The clock is set to internal, I used the MIDI setup in the Utilities but again, it appears as though there are no input or output controls. When I go to system preferenes - sound and select the Mbox2 it says it "the selected device has no output controls" the same happens on the input side. Yes, the imac still works fine with the internal inputs and outputs but when I try to use my audio interface it does not recognize it. I get audio from my MBox2 if I play a vido using quicktime, however no sound from either itunes, garageband or Imovie. I have looked over all of the post out there regarding this issue and have downloaded many possible sollutions and drivers. ![]() Prior to updating to 10.9 I was running 10.8 with NO problems, however as soon as I updated to 10.9 I lost use of my audio interface devices. I have a Digidesign MBox2 audio interface connected. ![]()
0 Comments
Leave a Reply. |